gongjigongyi.com

与米乐m6网页版登录入口代表实时聊天。 工作时间:上午 9:00 - 下午 5:00(太平洋标准时间)。

电话

致电我们

工作时间:上午9:00-下午5:00(太平洋标准时间)

下载

下载手册、产品技术资料、软件等:

下载类型
型号或关键字

反馈

How to configure and make resistivity measurements using Model 6487 picoammeter and Model 8009 resistivity test chamber?

问题:

How to configure and make resistivity measurements using Model 6487 picoammeter and Model 8009 resistivity test chamber?

答案:

Model 6487 is a picoammeter with a voltage source.
It acts like the 6517B for the resistivity measurement but does not calculate the resistivity, only resistance.
So it will source the voltage and measure the current, then calculate the resistance.
You have to apply the volume or surface resistivity factor derived for the Model 8009 test fixture.  See Model 8009 instruction manual for more details.
For surface it is 53.4.
For volume it is 22.9.

To configure the 6487 and 8009 to make this measurement follow the below steps.
1. Connect the triax on the 6487 to the triax on the 8009. Connect the voltage source HI and LO on the 6487 to the voltage inputs on the 8009 HI and LO. Connect the interlock between the 8009 and 6487.
2. Place the sample to be measured into the 8009 and close the lid.
3. Set the amount of voltage to output on the 6487 (E.g. 100V).
4. Set the appropriate amount of current compliance on the 6487.
5. Enable the output on the 6487.
6. Press ZCHK(Zero Check) on the 6487 to disable zero check.
7. Select either I or Ohms to make the measurement. If you choose ohms, then take the measurement from the front panel display.
8. Now multiply by 53.4 for surface resistivity (Ohms/square) or 22.9 for volume resistivity (Ohms-cm).


此常见问题适用于:

产品系列: Keithley 6400 系列皮安表

产品:

常见问题 ID 470656

查看所有常见问题 »